C05-01 Control Stick Assembly.
Used the arbor press to press the bushings into the C05-01 Control Stick Assembly.
I used a propane tourch and wire brush to heat and remove the powder coating on the C04-08 Horn Assembly where it goes into the bushings on the control stick assembly. I also used emery cloth to polish the area where the powder coating was removed.
I also wrapped some Emory cloth around some tubing to use to ream the bushing to get a proper fit.
I put the C04-03 Stick Grip and C04-08 Horn Assembly on the C05-01 Control Stick Assembly.
I drilled and up drilled to 1/4" size holes through the Stick Grip and Horn Assembly to bolt them in place on the Control stick Assembly.

Click on a link to view the video: