L02-01 Nose Landing Gear Assembly.
I shaped the travel stop plate to fit on the motor mount. I drilled a hole in the corner and then used the band saw to cut out the corner. I then used the scotch brite wheel to trim and shape the cut out to fit around the weld on the motor mount. I located and drilled the holes in the motor mount. I then installed the bolts to hold the travel stop plate.
I also attached the nut holding the 5/16th bolt through the steering cap and gear strut.
I also started looking at the boot for the control push rod for the steering. I decided I should prepare the steering push rod so I can be sure the boot will fit correctly.


Click on a link to view the video:

2013-12-18-CAM-1.wmv