F25-01R Right Hand Aft Side Panel.
I located and drilled pilot (#40) holes for the upper and lower splice plate. I used a piece of scrap angle to create an extension of the side panel on which the required measurements could be made per the plans. I started with the vertical splice plates. They were clamped in place and then pilot holes drilled using the existing holes in the splice plates as guides. Then the horizontal splice plates where clamped in place and pilot holes drilled. The two bolt holes in the lower vertical splice plate were step up drilled to 3/16th (#30, #21 and 3/16th).
The 5 inch cover plate (W18-02) was installed over the 4 Inch access hole per the plans.
All the clecos were removed so all the parts can be deburred and preped for riveting.


Click on a link to view the video:

2012-12-06-CAM-1.wmv