F02 Wing Rigging.
In addition to replacing the RH Fwd Attach Angle I have decided to replace the Attach Block that is next to that angle. That is the Attach Block on the Left Wing Main Spar on the right hand side. Today I fabricated that attach block from 1" x 1 1/4" bar stock. I drilled the two 1/4" holes and installed it on the end of the Left Hand Wing Spar. I used a "D" drill bit to get tight fit holes. I will drill the 3/8" hole after I install the new RH Fwd Attach Angle.
Vents.
Today I also started assembling the side vents that I purchased from Van's Aircraft. These are the vents used on the RV-12 and back vents for the RV-10. I have seen a few others use these vents on their Sonex. So I have decided that I will give them a try.


Click on a picture to enlarge it:

gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail