F02 Wing Rigging.
Rear Spar Carry Through.
Clamped the shear angle in place. I used the "Tight Fit" drill attachment and a 90 degree attachment to drill the pilot holes.
I removed the rear spar carry through assembly.
I finished drilling the pilot holes for the side attach angle. I then up drilled those holes to the #30 size for the rivets.
I put the assembly back in the fuselage and up drilled the holes through the shear angle and the fuselage cross piece.
I again removed the assembly.
I the attached the shear angle to the spar carry through. I drilled and up drilled those holes to the final size of #30.
I clecoed the side attach angles to the rear spar carry through. I then up drilled the holes to the #30 size. I used the drill press to carefully back drill the 1/4 inch hole through the side attach angles.
I then clecoed the rear spar assembly and side attach angles back in the fuselage to check that the pins alignment. The pins alignment was good.


Click on a picture to enlarge it:

gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail