W08-01R Right Hand Main Spar Assembly - I attached W11-10R RH Tie Down Fitting and W11-11 Outboard Vertical Stiffiner Angle to the spar assembly. I located these parts by the predrillied holes in the upper and lower spar caps. I clamped the parts in place and drilled 5/32 holes to match the predrilled holes. I then clecoed these parts to the assembly. I then used the predrilled holes in the angle to locate the four holes in the spar web. I drilled those four holes with the #40 #30 and #21 drill bits. I also up drilled the hole in the upper spar cap using the #21 bit. I then updrilled the trhee holes in the lower spar cap using a 3/16th bit. The parts where removed and deburred. The parts where reattached using clecos. The two AN3-6A and one AN3-7A bolts where installed per the plans. I then used the Sonex bolt and hammer method to install the 5 rivets per the plans.


Click on a picture to enlarge it:

gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail