F06-02 Glare Shield Assembly.
I fit the location of the Cross Tie Plates and the Instrument Panel Cross Tie. I clamped the Cross Tie Plates in location. I drilled the pilot holes that attach to the Glare Shield. I clamped the Instrument Panel Cross Tie in its location. I drilled the pilot holes throught the Cross Tie Plates and Instrument Panel Cross Tie. I used a yard stick ruler to be sure the cross tie was straight across the assembly. I drilled the pilot holes through the panel and the cross tie.

F06-01 Glar Shild Install.
I removed all the clecos from the glar shield assembly and put it into the fuselage with clecos. I drilled the 4 holes on each side through the cross tie plates, longerons and glar shiled. I then drilled all the remaining pilot holes through the glare shield and longerons. I filr the firewall attach angles in their locations. I drilled a few pilot holes through the attach angles and glare shiled. I then removed the upper firewall to gain access to the remaining pilot holes for the glare shield. I drilled all the holes to #40 and then #30. I then deburred abd riveted the attach angles to the glare shield. I put the upper firewall back in place with clecos. I drilled all the #40 pilot holes through the attach angles and the upper firewall.


Click on a picture to enlarge it:

gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail