F24-06 thru -09 Lower Cross Ties.
I used the band saw to trim the longer flange to the 3/4 in required per the plans. I layed out the notches / cut outs per the plans, I drilled holes in the corners and then used the band saw to do rough cuts. I used files and the scotch brite wheel to get the finished size, shape and radius. I trimmed the angle on the flanges required in the plans.
F24-09 Lower Cross Tie #5. I layed out and drilled the #40 pilot holes per the plans.

F24-02 thru -04 Upper Cross Ties.
I trimmed the angles on the flanges as required per the plans.


Click on a picture to enlarge it:

gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail gallery thumbnail